ReviewsEverbuild Lumberjack Wood Preserver - 5L - Clear
Description
Everbuild Lumberjack Wood Preserver is a low solvent, low odour solution based on micro-fine active technology. The fungicides and algaecides present in these formulations are finely dispersed so that wood penetration and effectiveness is much greater than standard wood preservation products. In addition, the use of ultra light fast pigments on the coloured variants give an even, fade-resistant finish, which will last for years. LUMBERJACK WOOD PRESERVER is fast drying and non flammable; application to wet timbers is possible without loss of performance. It is specifically designed to deeply penetrate all wood and joinery, giving long lasting protection from damage caused by wet rot, dry rot, decay and fungi.
Benefits
- Solvent-free formula
- Non-flammable
- Suitable for internal and external use
- Can be applied to damp timbers
Which Type Should I Choose?
- Wood Preserver - Clear
For use on interior or exterior rough sawn or planed timber, such as floorboards, joists, roof timbers, window frames and doors. This product is an ideal pre-treatment, which may be over-painted, varnished, or stained when dry (allow 48 hours drying time). On interior applications, it may also be left as the final finish for a natural wood effect. However, when used externally, over painting/staining is recommended, as this product does not repel water.
- Wood Preserver - Fir Green, Dark Oak, Golden Chestnut & Red Cedar
Ideal for general use on rough sawn or planed timber such as window frames, fences, sheds, cladding, horticultural timber, roof timber, joists etc. Fir Green is particularly useful for easy identification of treated timbers and horticultural work. These colours can be over painted, stained or varnished later, if required.
Limitations
- Ready to use - DO NOT dilute
- Always use coarse, rather than fine, mist generators
- Do not apply to surfaces where food is prepared
- Avoid contact with bitumen, roofing felt or plastic
- It is the user’s responsibility to determine suitability for use. If in doubt, contact Technical Services Department for advice
Surface Preparation
Shake well before use. Apply by brush, spray or dipping. Apply a minimum of two coats if brushing or spraying. The second coat should be applied after the first coat has soaked in, but before it is dry. Pay particular attention to thoroughly soaking the end grain. Where possible, dip the end grains of the timber for maximum protection.
Product Specification
| Brand | Everbuild |
| Colour | Clear |
| Product Type | Wood Preserver |
| Size | 5L |
Delivery, Cancellation & Returns
For our delivery, cancellation and returns policy.